Mounting The Control - ADEMCO Lynx Installation Instructions Manual

Wall Mounting
The illustration below shows the front assembly separated from the back plate.
1. Separate the front assembly from
the back plate by pressing on the
two locking tabs at the top of the
unit, and carefully disconnect the
ribbon cable from the front
assembly, leaving the ribbon
cable connected to the terminal
block PC board. The back plate
contains the terminal block for
making wiring connections.
2. Mount the back plate to a sturdy
wall, feeding the field wiring through
the opening in the back plate.
3. After wiring connections are made,
carefully reconnect the ribbon cable
to the front assembly PC board
connector (properly aligning the red
wire), then snap the front assembly
to the back plate so it is held by the
locking tabs.
Desktop Mounting
If desired, an optional mounting base (model LYNX-DM, purchased separately) allows the LYNX to be used on a
desktop.
1. If used, bring all wiring through the
bottom of the mounting base before
making connections to the LYNX.
2. After wiring connections have been
made, slide the LYNX onto the
mounting base locking tabs.
DO NOT disconnect the ribbon cable from the terminal strip board. Disconnect
the cable only from the front assembly board.

Mounting the Control

–5–