ADEMCO Lynx Installation Instructions Manual page 23

Enroll mode
IA 0 = skip to the VOICE DESCRIPTOR prompt
(1C); if zone type is "00," skip to DELETE
SERIAL NUMBER prompt
1 = enter now and proceed to SERIAL
NUMBER prompt (1b)
Serial number
I Enter the transmitter's 7-digit serial number.
b
[*] = continue to prompt 1C, unless zone type is
00, which will return system to DELETE
SERIAL NUMBER prompt (F)
[#] = return to previous prompt
Voice descriptor
IC
0 = skip to next zone (A)
1 = enter descriptor mode; existing descriptor
for this zone will be announced
Descriptor 1
I
Enter [#] + 2-digit vocabulary index number† of
d vv
first descriptor word for this zone.
6 = accept word and advance to descriptor 2
(descriptor 2 will be announced)
8 = accept word and advance to next zone
(prompt A) – entire zone descriptor will be
announced
Press any other key to repeat the selected word.
Descriptor 2
IE Enter [#] + 2-digit vocabulary index number† of
second descriptor word for this zone.
6 = accept word and advance to descriptor 3
(descriptor 3 will be announced)
8 = accept word and advance to next zone
(prompt A) – entire zone descriptor will be
announced
Press any other key to repeat the selected word.
Descriptor 3
IF Enter [#] + 2-digit vocabulary index number† of
third descriptor word for this zone.
6 or 8 = accept word and advance to next zone
(prompt A) – entire zone descriptor will
be announced
Press any other key to repeat the selected word.
If the transmitter's serial number has not been previously entered, you may
enter the enroll mode now by entering "1." Enter "0" if you wish to enter
the transmitter later, using the *83 Sequential Mode described in the *83
Sequential Mode section later in this manual.
Manually enter the 7-digit serial number printed on the transmitter. If you
enter an incorrect digit, press the [#] key to backup to that digit and
reenter the correct digit.
When all 7 digits are entered, press the [*] key. Each digit will be re-
displayed, and the keypad will beep once for digits 1-6, 3 times for the
last digit. If less than 7 digits are entered, the un-entered digits will
dsiplay "F." If too many digits have been entered, the first 6 digits will
be saved, along with the last digit that was entered (entering
123456789 yields serial number 1234569).
If the serial number is correct, press [*] again to save it and advance to
the next prompt.
If the serial number is not correct, press [#], which deletes the number
and returns to the ENROLL MODE prompt (1A), allowing you to
reenter the number.
If the serial and loop number combination is already present in the
system, the keypad will emit a single long beep.
Each zone can have a voice descriptor of up to 3 words that will be
announced whenever the system announces status for that zone.
† see *84 Assign Zone Voice Descriptors section for vocabulary index
† see *84 Assign Zone Voice Descriptors section for vocabulary index
† see *84 Assign Zone Voice Descriptors section for vocabulary index
–23–