Zone Programming Mode - ADEMCO Lynx Installation Instructions Manual

This is an interactive menu mode that is used to program zone numbers, zone types, alarm and report codes, and to
identify the type of loop input device. This mode can also be used for entering 5800 Series transmitter serial
numbers.
NOTE: There are two methods for entering transmitter serial numbers. The first method is by using *56 Zone
Programming mode (described below). The second method is by using *83 Sequential mode. Note that the *83
Sequential mode requires that all zone information first be entered using *56 Zone Programming mode.
You must refer to these instructions or to the Program Form while programming the system because the keypad
display does not show prompt titles. Instead, prompts are indicated by a number/letter combination.
The prompts for *56 are as follows:
A 01 Zone Number -------------------------- for entering the zone number
b Zone Type ------------------------------ for entering zone type
C Report Code---------------------------- for entering the zone's report code
d Input Type ------------------------------ for entering the transmitter's input type
E Loop Number -------------------------- for entering the transmitter loop number
F Delete Serial Number? --------------- for deleting existing serial number
1A Enroll Mode? -------------------------- selects serial number enroll mode
1b Serial Number-------------------------- for entering transmitter's serial number
1C Voice Descriptor? --------------------- selects voice descriptor mode
1d Descriptor 1 ---------------------------- for entering first descriptor word
1E Descriptor 2 ---------------------------- for entering second descriptor word
1F Descriptor 3 ---------------------------- for entering third descriptor word

*56 Zone Programming Mode

–21–