Zone List Menu Mode - ADEMCO Lynx Installation Instructions Manual

While in Program mode, press
output devices (programmed in
NOTES:
• Any list may include any or all of the system's zone numbers.
• A zone list can be assigned to more than one Powerline Carrier Device.
The prompts for *81 are as follows:
81
A 01
b
C
d
E
The following explains these prompts in detail. The left two columns identify the prompts and list the available
entries. The right-most column provides a further explanation of the entries.
NOTE: Entry of a number other than one specified will give unpredictable results.
Zone list programming
8I
0 = exit mode
1 = enter mode
Zone list number
A 0I
01-03 = zone list number to be programmed
00 = exit Zone List mode
[*] = continue
Zone entry to list
b
01-41, 95, 96, 99 = zone numbers to add to
zz
zone list
[*] = accept zone number and enter the next
zone number
00 = accept zone number(s) and continue to
next prompt
Delete entire zone list?
C
0 = don't delete; continue to next prompt
1 = delete the current zone list
Delete zones from list?
d
1 = continue to delete zones prompt
0 = don't delete; continue to next zone list
number (prompt A....01)
[#] = return to previous prompt
Delete zones
E
Enter each 2-digit zone number to be deleted
from the current zone list, followed by the [*]
key.
[*] = delete zone and enter next zone to be
deleted
00 = delete zone and return to next zone list
number (prompt A....01) desired.
* 81 to enter Zone List Menu Mode. This mode is used to program zone lists for
* 80 menu mode) or Chime-by-Zone in Zone List 3.
Zone List Programming -------------- Main Menu prompt
Zone List Number --------------------- for entering the zone list number to be programmed
Zone Entry to List --------------------- for entering zones to the assigned zone list
Delete Entire List? -------------------- for deleting the entire zone list and its contents
Delete Specific Zones From List? -- Selects whether to delete zones or return to next zone list number
Delete Zones --------------------------- for deleting specific zones from the current zone list

*81 Zone List Menu Mode

Pressing 1 advances to the next prompt below.
Pressing 0 exits mode, upon which this prompt blinks, indicating the mode
is inactive. Press [*] + any field number to go to that field.
Enter the Zone List Number 01, 02, or 03 to program (or 00 if no zone lists
are used).
Enter each zone number to add to the zone list by first entering the zone
number, then the [*] key (for example, 01*, 02*, 03*). After all zones
desired are entered, press 00 to advance.
To delete the zone list, enter 1. All zones in the zone list will be deleted
automatically and programming will return to the ZONE LIST NUMBER
prompt.
To save the zone list or delete specific zones from the list, enter 0.
To save the entire zone list, enter 0 and programming will return to the
ZONE LIST NUMBER prompt.
To delete a zone or zones in a zone list enter 1.
After all zones to be deleted are entered, enter 00 to return to the ZONE
LIST NUMBER prompt so that another list can be programmed, if desired.
–27–