Table of Contents
Advertisement
Getting started
Battery installation and charging
Install the battery, as shown below. Once you have installed the battery, the
screen indicates the battery status (see the following table). If necessary,
place the handset in the telephone base or charger to charge the battery. For
best performance, keep the handset in the telephone base or charger when
not in use. The battery is fully charged after 16 hours of continuous charging.
If the screen shows Place handset in charger and flashes, you need to
charge the handset without interruption for at least 30 minutes to give the
handset enough charge to use the telephone for a short time. The following
table summarizes the battery charge indicators and actions to take.
Battery indicators
The screen is blank, or
shows Place handset in
charger and (flashing).
The screen shows
Low battery and (flashing).
The screen shows
HANDSET X.
NOTE: If you are on a phone call in low battery mode, you hear four short beeps every
minute.
Step 1
Plug the battery connector securely into the socket inside the handset
battery compartment. Insert the supplied battery with the label THIS SIDE UP
facing up, as indicated.
Battery status
Battery has no or very little
charge. The handset cannot
be used.
Battery has enough charge
to be used for a short time.
Battery is charged.
8
Action
Charge without interruption
(at least 30 minutes).
Charge without interruption
(at least 30 minutes).
To keep the battery charged,
place it in the telephone base or
charger when not in use.
Advertisement
Table of Contents
