Adjusting Calfpad Height; Adjusting The Hanger Abduction Angle - Invacare Action3 Junior Service Manual

SECTION 2—FRONT HANGERS
Ad justing the Footplate Angle
1. Using the mounting screw (M6), adjust to the desired angle (Tooth Plates) by rotating
the footplate.
2. Securely tighten mounting screw (M6).
3. If necessary, repeat STEPS 1-2 to adjust remaining footplate angle.
Adjusting Calf pad Height
4. Loosen the fixing screw that secure the calf pad bracket to the elevating legrest
assembly.
5. Slide the calf pad bracket up or down until the desired calf pad height is obtained.
6. Firmly tighten the fixing screw securing the calf pad bracket to the elevating legrest
assembly.
7. If necessary, repeat STEPS 1
Locking Knob
Fixing Screw
Knob
FIGURE 2.5 Adjusting Elevating Legrest Height and Calf pad Height
Ad justing the Hanger Abduction Angle (2 positions 0°or 30°)
1. Loosen fixing screw (M5) securing the locking mechanism of the hanger on the
vertical tube of the frame.
2. Adjust to desired angle (0° or 30°), firmly tighten fixing screw (M5).
3. If necessary, repeat STEPS 1-2 to adjust remaining hanger angle.
3 to adjust remaining calf pad bracket.
-
1 0
Calf pad
Mounting
Screw (M6)