Adjusting The Tension Of The Flip Up Footplate; Installing/Removing The Power Elevating Legrests - Invacare Formula Owner's Operator And Maintenance Manual

Cg powered seating tilt recline elevate tilt/recline

Hide thumbs Also See for Formula:

Table of Contents

SECTION 6—FRONT RIGGINGS

Adjusting the Tension of the Flip Up Footplate

NOTE: For this procedure, refer to FIGURE 6.20.

NOTE: The tension can be adjusted to increase or decrease the rotation effort of the flip up

footplates.

1. Loosen the mounting screw on the front rigging angle hinge to decrease the rotation

effort.

NOTE: DO NOT remove the footplate mounting screw.

2. Tighten the front rigging angle hinge mounting screw to increase the rotation effort.

3. Repeat STEPS 1 and 2 for the other footplate.

Footplate

Center Mount

Front Rigging

Mounting Screw

FIGURE 6.20 Adjusting the Tension of the Flip Up Footplate

WARNING

To prevent personal injury, ALWAYS verify proper positioning of legs and feet prior

to use. Individual user weight may impact the rate of travel for each legrest

assembly. If simultaneous operation is desired, select a speed which allows for the

most uniform travel.

DO NOT insert fingers between legrest components, otherwise personal injury may

occur.

CAUTION

NEVER allow items to become trapped between the legrest assemblies, otherwise

damage to the power legrests may occur.

Ensure that all parts of both power legrests are clear of any obstructions before rais-

ing and lowering, otherwise damage to the power legrests may occur.

NOTE: For this procedure, refer to FIGURE 6.21 on page 56.

Part No 1143155

Formula™CG Powered Seating

Table of Contents