8 SETUP/MAINTENANCE
Removing/Installing the Rear Battery
For this procedure, refer to FIGURE 2 and FIGURE 3 on page 82.
Reverse this procedure to install the rear battery.
1.
Remove the two thumb screws securing the rear shroud to the rear shroud stand offs (FIGURE 2).
2.
Remove the rear shroud from the wheelchair base frame.
Take note of position and orientation of the tie-wraps and wiring bundles before cutting necessary tie-wraps and
repositioning the wiring bundles.
3.
Locate the two wiring bundles, one on each side of the controller and if necessary, cut the tie-wraps securing the wiring bundles to the controller
bracket.
Wheelchair Base Frame
Mounting Screws
Rear Shroud
Invacare® FDX®
Mounting Screw
Stand Offs
FIGURE 2 Removing the Rear Shroud
80
Wheelchair Base Frame
Controller Bracket
Stand Offs
Mounting Screw
Part No 1163181