System Settings - Edirol PCR-M30 Owner's Manual

System settings

Here's how you can make various system settings for the PCR-M30/50/80.
fig.edt
1
Press the [EDIT] button.
The display will indicate "EDT."
fig.sy0
2
Press the [SYSTEM] key.
The display will indicate "SY0."
3
Use the [0] - [A] keys to specify the System setting that you want to set, and then press the
[ENTER] button.
Confirm what's indicated and use the appropriate method to make the setting.
Mode
F8 CLOCK ON/OFF
F8 CLOCK DEFAULT
TEMPO
F8 CLOCK PORT SET
VELOCITY CURVE
KEYBOARD PORT SET
H-ACTIVITY ON/OFF
USB MIDI DRIVER
MODE
STARTUP MEMORY
FACTORY RESET
MIDI I/F MODE
KEY VELOCITY
Key-
Content of the setting
board
0 Specify whether F8 Clock is to be transmitted.
If "F8 CLOCK ON/OFF" is ON, specify the default
value of the F8 Clock. After the power is turned on,
1
this tempo will continue to be output until you
move a controller to which TEMPO is assigned.
If "F8 CLOCK ON/OFF" is ON, specify the port
2
from which the F8 Clock is to be transmitted.
When you play the keyboard of the PCR-M30/50/
80, note messages will be transmitted with a veloc-
ity value that corresponds to your playing
3 strength. By setting the VELOCITY CURVE, you
can modify the keyboard's sensitivity and the
curve that is followed when the velocity value
changes.
Specify the port from which messages produced by
4 the BENDER lever of the keyboard are to be trans-
mitted.
Turn this ON if you are using certain applications
5 (such as Pro Tools LE). When ON, "90 00 7F" will
be output from PCR 2 approximately every 500 ms.
Specify the type of USB MIDI driver used for USB
connection.
6
* The setting will take effect the next time you turn
on the power
Specify the memory that will be selected when the
7
power is turned on.
Restore all settings of the PCR-M30/50/80 to their
8
factory-set condition.
Specify whether the PCR-M30/50/80 will function
9
as a MIDI interface using its MIDI connectors.
Specify whether the transmitted velocity value will
vary according to the keyboard sensitivity and
A
curve you selected in "VELOCITY CURVE", or
will always be transmitted at a fixed value.
Setting
Default
method
OFF p. 90
120 p. 90
PORT 1 p. 90
1-MEDIUM p. 91
PORT 1 p. 92
OFF p. 92
Original
p. 92
Driver
GM2 p. 93
- p. 93
ON p. 94
TOUCH p. 95
89