Getting Connected and Installing Drivers (Macintosh)
Mac OS settings
Make the following settings so that you can use the MIDI functionality of the
PCR-M30/50/80. For a connection diagram, refer to "Basic connections
and MIDI flow" (p. 40).
1
Use the USB cable to connect the PCR-M30/50/80 to your computer.
1. With the power switch turned OFF, connect the AC adaptor to the
PCR-M30/50/80.
2. Connect the AC adaptor to an electrical outlet.
3. Use the USB cable to connect the PCR-M30/50/80 to your computer.
2
Set the PCR-M30/50/80's power switch to the ON (DC) position.
3
Open the Applications folder of your Macintosh hard disk. In the Utilities
folder, double-click Audio MIDI Setup to open the Audio MIDI Setup.
fig.osx2a-e
4
Click the MIDI Devices tab.
5
Click "Add Device" four times.
Four new external MIDI devices will appear.
6
Specify a name for each new external device.
1. Click Show Info.
2. Enter the name in the
Device Name field.
Enter the following for
each new external
device.
Device Name
30
5
Click Add Dvice
First
Second
PCR MIDI IN, OUT
PCR
4
Click MIDI Devices
6
Click Show Info
Third
Fourth
PCR 1
PCR 2
Once the connections have
been completed, turn on
power to your various
devices in the order
specified. By turning on
devices in the wrong
order, you risk causing
malfunction and/or
damage to speakers and
other devices.
Connect the cable to the
USB connector of the
Macintosh itself, not to the
USB connector of the
keyboard.
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
before the unit will operate
normally.
For details on MIDI device
settings, refer to the
owner's manual for the
software you are using.