Freemidi Settings - Edirol PCR-M30 Owner's Manual

Getting Connected and Installing Drivers (Macintosh)

FreeMIDI settings

1
Use the USB cable to connect the PCR-M30/50/80 to your computer.
1. With the power switch turned OFF, connect the AC adaptor to the
PCR-M30/50/80.
2. Connect the AC adaptor to an electrical outlet.
3. Use the USB cable to connect the PCR-M30/50/80 to your computer.
2
Set the PCR-M30/50/80's power switch to the ON (DC) position.
* Connect the cable to the USB connector of the Macintosh itself, not to the USB
connector of the keyboard.
3
From the CD-ROM, drag the Driver E (Mac OS 9,8) - FreeMIDI Setting
folder into the FreeMIDI Applications folder on the hard disk of your
Macintosh to copy it there.
4
Open the FreeMIDI Applications folder from the location into which you
installed FreeMIDI, and double-click the FreeMIDI Setup icon to start it up.
5
The first time you start up, use the following procedure.
1. A dialog box saying "Welcome to FreeMIDI!" will appear.
Click [Continue].
2. The FreeMIDI Preferences dialog box will appear.
Click [Cancel].
3. The About Quick Setup dialog box will appear.
Click [Cancel].
36
Once the connections have
been completed, turn on
power to your various
devices in the order
specified. By turning on
devices in the wrong
order, you risk causing
malfunction and/or
damage to speakers and
other devices.
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
before the unit will operate
normally.
If you are using the PCR in
conjunction with other
MIDI devices, make
settings as described in
Readme_E.htm located in
the Driver E (Mac OS 9,8)
folder of the CD-ROM.
When "OMS is installed
on this computer..."
appears, click [FreeMIDI].