Sys Ex. Assign - Edirol PCR-M30 Owner's Manual

Use MIDI functionality

SYS EX. ASSIGN

Here's how you can assign a system exclusive message to a controller. Advanced mode 2 lets
you assign a single-byte system message (System realtime message, tune request).
Advanced modes 3 and 4 let you assign any desired message.(Input up to 24 bytes)
Mode number
Basic mode
Advanced mode 1
Advanced mode 2
Advanced mode 3
Advanced mode 4
SYS EX. ASSIGN can calculate the checksum automatically, and lets you specify a variable
(data) range or embed a channel/block number within the message.
(➔"Sys Ex. ASSIGN items" (p. 74))
In SYS EX. ASSIGN, the input mode will be HEX mode(p. 49).
fig.edt
1
Press the [EDIT] button.
The display will indicate "EDT."
fig.r-1
2
Slightly move the controller to which you want to assign the system
exclusive message. In the case of a button, press that button.
The display will indicate the number of the selected controller.
3
Confirm what's indicated, and press the [ENTER] button.
fig.se0
4
Press the [SYSTEM Ex.] key.
5
If you want to select an Advanced mode, press a key from [1] to [4].
The selected mode will blink in the display.
6
Confirm what's indicated, and press the [ENTER] button.
Then continue with the procedure described in Basic mode or Advanced mode.
For some actual examples of settings, refer to "Examples of assigning system exclusive
messages" (p. 77).
72
Key-
Mode
board
0 Sys Ex. message
1 Sys Ex. message
2 Single byte system message -
3 Any desired MIDI message Default range
4 Any desired MIDI message Assignable
Required
Value range
ending
Default range Input F7
Assignable Input F7
-
Specified num-
ber of bytes
Specified num-
ber of bytes
Notes/restrictions
1st byte fixed at F0
1st byte fixed at F0
[0-5, 7, 9, D, E] [DATA]
[CHECKSUM] buttons are invalid
[CHECKSUM] button is invalid
[CHECKSUM] button is invalid