Advanced Mode - Edirol PCR-M30 Owner's Manual

Use MIDI functionality

■ Advanced mode

Advanced mode 1 of NOTE ASSIGN lets you specify the velocity value in addition to the items
of Basic mode.
1. Press the [EDIT] button.
2. Slightly move the controller to which you want to assign a Note message.
In the case of a button, press that button.
The display will indicate the number of the selected controller.
3. Verify that the display indicates the correct controller, and press the [ENTER] button.
4. Press the [NOTE] key and then press key [1].
The display will indicate "NT1."
5. Press the [ENTER] button.
6. Input the channel.
7. Press the [ENTER] button.
8. Input the note number.
fig.v
9. Press the [ENTER] button.
The display will indicate "V–."
10. Input the velocity.
fig.p
11. Press the [ENTER] button.
The display will indicate "P–."
12. Specify the output port. (➔"Specifying the port" (p. 59))
13. If you are making an assignment for a button, specify the button mode.
(➔"Specifying the button mode" (p. 59))
• If you set [S1--S8], [R1--R8], or [P2] to NOTE ASSIGN, the specified velocity value will be
transmitted when the controller is at its maximum position. If the controller is lowered
slightly below its maximum position, note messages with a velocity of zero will be
transmitted.
• If you assign this to [B1–B6] or [P1], the specified velocity value will be transmitted when
you turn the controller on. When you turn the controller off, a note message with a velocity
value of 0 will be transmitted.
*1 The -- area displays the currently set value. If it has not been set, the default setting will be displayed. Even if you change the type or mode
58
of the MIDI message that is assigned, the default setting will be displayed. This will be lit if the value is the same as the currently set value,
or will blink if the value is different.
*1 Reference
*1 Reference