Fixed In System Firmware 7.2.10 Or Later - Fujitsu SPARC Enterprise T5140 Product Notes

Issues Fixed in System Firmware 7.2.10.a or Later (Continued)
TABLE A-5
CR ID Description
6734788 During the system operation, a panic may occur with
the PCIEX-8000-6D message output.
6784914
This occurs more frequently with a high-load access
to the CD/DVD/USB device; however, even if the
DVD drive is not used, vold(1M) of Solaris OS is
accessing to the DVD drive periodically, and a panic
may occur on rare occasions.

Fixed in System Firmware 7.2.10 or Later

Issues Fixed in System Firmware 7.2.10 or Later
TABLE A-6
CR ID Description
6967929 After a PSU failure occurred on the T5140 server,
even though you replaced the faulty PSU, the fault
indication may not be cleared or the Service Required
LED and the [REARPS] LED may remain on. Also,
in the result of the showenvironment command of
ALOM CMT compatible shell, /SYS/PS_FAULT
may remain ON. For details, see
Replaced on the T5140 Server, the Fault Indication
May Not Be Cleared (CR 6967929)" on page
6948680 When you change the system diagnostics settings
(/HOST/diag) from "Remote Control"->
"Diagnostics" tab in the ILOM Web interface, the
value of "Trigger" fails to be set with a pop-up
message "Error:Invalid property value," if the
following value is singly selected for the
"Trigger".
• Power On
• User Reset
6947945 When you mount a Fujitsu 4Gbps Fibre Channel card
and start the system, the 4Gbps Fibre Channel card is
falsely recognized as a F20 card in the ILOM CLI
interface. Also, the slot number is falsely displayed.
In addition, the false recognition and the false display
may occur also in the FRU Status of the prtdiag -
v command output.
For details, see
Falsely Recognized as F20 Card (CR 6947945)" on
page 85.
82 SPARC Enterprise T5140 and T5240 Servers Product Notes • November 2012
"After a Faulty PSU
"Fujitsu 4Gbps Fibre Channel Card Is
Workaround
Note - Fixed in System Firmware 7.2.10.a or later.
Only use the DVD drive to install the Solaris OS or
software or to apply a patch or PTF (Program
Temporary Fix).
Workaround
Note - Fixed in System Firmware 7.2.10 or later.
None.
The replacement PSU has no errors. Since this is just
an issue of display, perform the ILOM reset operation
to recover. The ILOM reset operation has no impact on
the system. For details, see
Replaced on the T5140 Server, the Fault Indication
May Not Be Cleared (CR 6967929)" on page
84.
Note - Fixed in System Firmware 7.2.10 or later.
None.
Use the set /HOST/diag trigger= (value)
command from the ILOM CLI interface.
Note - Fixed in System Firmware 7.2.10 or later.
None.
This can be safely ignored. To check the fibre channel
card mount, use IO Devices of the prtdiag
command of Solaris OS.
For details, see "Fujitsu 4Gbps Fibre Channel Card Is
Falsely Recognized as F20 Card (CR 6947945)" on
page 85.
"After a Faulty PSU
84.