Fixed In System Firmware 7.2.2.E Or Later - Fujitsu SPARC Enterprise T5140 Product Notes

SYS/MB
SYS/MB
SYS/MB
SYS/MB
SYS/MB
SYS/MB
SYS/PS0
SYS/PS0
SYS/PS1
SYS/PS1
Workaround: None. Ignore this issue because it is only a display error.

Fixed in System Firmware 7.2.2.e or Later

Issues Fixed in System Firmware 7.2.2.e or Later
TABLE A-9
CR ID Description
6835857 After the system power-on, when Solaris OS started,
the "chip reset error!" message may appear
and Solaris OS may fail to start.
6819987 For DC input power models, the following event log
might be repeatedly collected:
Sample output from the showlogs command:
IPMI |minor : "ID = 20a : 03/11/2009
: 02:31:48 : Current :
/PS0/CUR_FAULT : State Asserted"
IPMI |minor : "ID = 20b : 03/11/2009
: 02:31:51 : Temperature :
/PS0/TEMP_FAULT : State Asserted"
IPMI |minor : "ID = 20c : 03/11/2009
: 02:31:54 : Current :
/PS0/CUR_FAULT : State Deasserted"
IPMI |minor : "ID = 20d : 03/11/2009
: 02:31:57 : Temperature :
/PS0/TEMP_FAULT : State Deasserted"
6802433 For DC input power models, the INPUT limit value
included in the output from the showpower -v
command may differ between /SYS/PS0 and
/SYS/PS1. The /SYS/PS1 value is correct. For
examples, see
Output from the showpower -v Command May
Differ between /SYS/PS0 and /SYS/PS1 (CR
6802433)" on page
100 SPARC Enterprise T5140 and T5240 Servers Product Notes • November 2012
"For DC Input Power Models, the
104.
V_VCOREL
V_VCORER
V_+1V5_IO
V_VMEML
V_VMEMR
V_VBAT
V_IN_MAIN
V_OUT_MAIN
V_IN_MAIN
V_OUT_MAIN
Workaround
Note - Fixed in System Firmware 7.2.2.e or later.
Power off the system, wait for about 180 seconds, and
then power on the system.
Note - Fixed in System Firmware 7.2.2.e or later.
None.
If the Service Required, Overtemp, and Power Supply
Service Required LEDs on the server are off, ignore the
event log items. If one of these LEDs is on, indicating
that a power supply problem or temperature-related
problem has occurred, correct the problem.
Note - Fixed in System Firmware 7.2.2.e or later.
None.
Ignore this issue because it is only a display error.
ok
ok
ok
ok
ok
ok
warning (-48volts)
ok
warning (-48volts)
ok