Cable Management Arm - Fujitsu SPARC Enterprise T5140 Product Notes

During the RAID 1 operation
■
■
Notes on the raidctl command
■
■

Cable Management Arm

The SPARC Enterprise T5140 server doesn't support the cable management arm (CMA).
The following restrictions apply when using a CMA on SPARC Enterprise T5240 server:
The maximum capacity of the CMA is as follows:
■
■
■
Optical fiber cables cannot be accommodated in the CMA. Route the cables through the
■
free space on top of the CMA.
Cables with a cable core (such as SCSI cables) cannot be accommodated in the CMA.
■
Route the cables through the free space on top of the CMA.
Moreover, if it hampers to install optional products that are subject to the following structural
restriction, first uninstall and remove the CMA.
Cables with large connectors (such as for an XVR-300 or SAS card) must be connected to
■
the top PCIe slot.
16 SPARC Enterprise T5140 and T5240 Servers Product Notes • November 2012
In some cases, RAID controller cannot conclude the disk is completely in failure, and
system slowdown may occur. To do maintenance in this status, follow the procedures
below.
1. Delete the RAID.
2. Replace all the disks related to the RAID.
3. Rebuild the RAID 1.
4. Restore the data from the backup media.
The following options of the raidctl command can not be used because the
hardware specifications do not support them.
raidctl -C -r 1E
raidctl -c -r 1E
raidctl -a
raidctl -p
raidctl -C -z
AC input power model : 2 AC cables and 6 RJ45 cables
DC input power model : 6 DC cables and 6 RJ45 cables
(To create a RAID1E)
(To create a RAID1E)
(To assign hot-spare disks)
(To set the cache)
(To specify the volume capacity)