Solaris Os Issues - Fujitsu SPARC Enterprise T5140 Product Notes

Sparc enterprise
Hide thumbs Also See for SPARC Enterprise T5140:
Table of Contents

Advertisement

Solaris OS Issues

This section describes Solaris OS issues known to exist at this release of the SPARC
Enterprise T5140 and T5240 servers.
Solaris OS Issues
TABLE 3-3
CR ID
Description
6836653
USB SATA DVD drive is not supported for the
following versions of the Solaris OS:
• Solaris 10 8/07 OS
• Solaris 10 5/08 OS
Note - USB SATA DVD drive is supported for the
later versions of the Solaris 10 OS, beginning with
Solaris 10 10/08 OS.
n/a
While booting SPARC Enterprise T5240 server (16
HDD type), mpt driver outputs the following
WARNING message:
Encode devid failed for path target:##,
lun:#, SAS address:################
n/a
In SPARC Enterprise T5140 and T5240 servers,
when rebooting is repeatedly executed, the following
WARNING messages might be stored in
/var/adm/messages.
px: [ID 781074 kern.warning] WARNING:
px0: spurious interrupt from ino 0x13
px: [ID 548919 kern.info] su-0#0
px: [ID 100033 kern.info]
n/a
System shutdown may fail.
Workaround
To install Solaris 10 8/07 OS or Solaris 10 5/08 OS
on a server equipped with a USB SATA DVD drive,
install the Solaris OS from the install server and
apply the mandatory patches, the latest periodic PTF,
and the latest recommended security patches.
For the installation procedures, see
Installing Solaris 10 8/07 OS and Solaris 10 5/08 OS"
on page
34.
To confirm whether a USB SATA DVD drive is
mounted on your server, see
USB SATA Drive Unit Is Mounted" on page
This message shows the failure in the setting of the
SES device installed in SPARC Enterprise T5240
server (16 HDD type). Because this device is not
used, you can ignore this message.
This message shows that interrupt without the reason
was detected when su (serial port) driver processes
interrupt.
Because this message doesn't influence the system,
you can disregard this message.
Do not attempt a shutdown before boot processing is
completed.
Start shutdown processing after ensuring that boot
processing is completed or waiting for an adequate
period of time (at least 10 minutes).
Chapter 3
"Notes on
"To Confirm Whether a
35.
Known Issues
33

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sparc enterprise t5240

Table of Contents