Solaris Os Issues Fixed In Solaris 10 10/09 - Fujitsu Sparc Enterpise M8000 Product Notes

Solaris OS Issues and Workarounds for All Supported Releases (Continued)
TABLE 7
CR ID Description
6668237 After DIMMs are replaced the corresponding
DIMM faults are not cleared on the domain.
6745410 Boot program ignoresthe Kadb option which
causes the system not to boot.
6794630 An attempt to use the GUI to install Solaris in
a domain larger than 2TB might fail.
6872501 If 139555-08 has been applied to the domain,
cores are not offlined when requested by the
XSCF. This CR effects only Solaris 10 5/09,
Solaris 10 10/09, and an earlier version of
Solaris OS with patch 139555-08.
6888928 IPMP interface fails since probe packets are not
sent through that interface. Problem occurs
with M3000/M4000/M5000/M8000/M9000
servers running any Solaris release running
IPMP with patch 141444-09 installed.

Solaris OS Issues Fixed in Solaris 10 10/09

TABLE 8
them in supported releases earlier than Solaris 10 10/09.
Solaris OS Issues Fixed in Solaris 10 10/09
TABLE 8
CR ID Description
6572827 The prtdiag -v command reports PCI bus
types incorrectly. It reports "PCI" for PCI-X leaf
devices and "UNKN" for legacy PCI devices.
54 SPARC Enterprise M8000/M9000 Servers Product Notes for XCP Version 1092 • April 2010
lists issues that have been fixed in Solaris 10 10/09 OS. You might encounter
Workaround
This has been fixed in patch 143527-01.
[Workaround]
Use the following commands:
# fmadm repair fmri|uuid
# fmadm rotate
Use kmdb instead of kadb.
Use the Command Line interface to install
Solaris.
This has been fixed in patch 143359-02.
[Workaround]
Use fmdump(8) with its -v option on the
Service Processor to identify the faulty core.
Once identified, use psradm(1M) on the
domain to offline the core.
This has been fixed in patch 142900-02.
[Workaround]
Disable probe-based failure detection.
Workaround
This has been fixed in patch 141444-09.
[Workaround]
No workaround is available.