Fixed In System Firmware 7.1.6.D Or Later - Fujitsu SPARC Enterprise T5140 Product Notes

Fixed in System Firmware 7.1.6.d or Later

Issues Fixed in System Firmware 7.1.6.d or Later
TABLE A-11
CR ID Description
6735254 After host activation, the CPU strand component may
become disabled.
Example of display from host side:
T5140, No Keyboard
Copyright 2008 Sun Microsystems,
Inc. All rights reserved.
OpenBoot 4.28.8, 32544 MB memory
available, Serial #XXXXXXXX.
Ethernet address XX:XX:XX:XX:XX:XX,
Host ID: XXXXXXXX.
ERROR: The following devices are
disabled: MB/CMP1/P0
figures may change depending on the system
configuration.
6728569 When you logged in to ILOM from SSH client, it
takes 20 to 30 seconds or more before the login
completes (before the ILOM prompt "->" or "SC>"
displayed). It normally takes about 10 seconds.
6703910 The built-in fan high-speed periodical diagnosis
activates every few hours, and the built-in fan
operates at high speed. At this time, fan speed of the
built-in fan goes up to the maximum, which increases
the fan noise of the built-in fan.
6694475 It is impossible to use options of the showfru
command on the ALOM CMT compatibility shell.
All information will be displayed regardless of the
option specified.
showfru [-g lines] [-s|-d] [FRU]
-g: Only the specified line
-s: Only static information
-d: Only dynamic information
Workaround
Note - Fixed in System Firmware 7.1.6.d or later.
None.
Recovery procedure: Execute recovery by using the
following procedure.
If the phenomenon occurs even after executing the
recovery procedure, the CPU component may be
faulty. Replace the CPU component.
[For ILOM]
1. Delete the CPU strand component from the asr-db
blacklist.
Example:
*The numerical
• set /SYS/MB/CMP1/P0 component_state=
enabled
[For ALOM]
1. Delete the CPU strand component from the asr-db
blacklist.
• enablecomponent /SYS/MB/CMP1/P0
Note - Fixed in System Firmware 7.1.6.d or later.
Power off the system, disconnect the power cord, wait
for about 180 seconds, and then reconnect the power
cord.
Note - Fixed in System Firmware 7.1.6.d or later.
None.
The fan high-speed test has no impact on system.
Note - Fixed in System Firmware 7.1.6.d or later.
None.
Appendix A Fixed Issues 113