Fujitsu SPARC Enterprise T5140 Product Notes page 112

Issues Fixed in System Firmware 7.2.2.e or Later (Continued)
TABLE A-9
CR ID Description
6781831 After enabled the NTP function of ILOM firmware,
when you power on the host, the Solaris OS time may
be lagged compared to the adjusted accurate time of
ILOM firmware.
Example of Solaris OS system log when the time
went backward for several tens of seconds
Nov 29 19:59:24 XXX genunix: [ID 904073
kern.notice]
Nov 29 19:58:23 XXX genunix: [ID 540533
kern.notice] ^MSunOS Release 5.10
Version Generic_137137-09
64-bit
6781815 After the ILOM reset or the power cord removal and
insertion, when the server powered on, Solaris OS
startup at the ok prompt of OpenBoot PROM (OBP)
using the boot command may fail.
Error output example:
{0} ok boot
ERROR: All device paths in boot-
device have failed. (*)
{0} ok
It cannot refer to the device paths that configured in
the OpenBoot PROM environmental variable boot-
device and fails to start Solaris OS.
6743343 Test Alert generation (alert test transmission) may not
be possible, depending on the "Alert Type" and
"Event" under the alert rule settings.
6738989 The SNMP tab of the ILOM Web interface does not
have an item for setting engineid.
6733632 When the ILOM "show -level all /SYS"
command is executed, information under
/SYS/MB/SP is not displayed.
When "show -level all /SYS/MB" is
executed, information under /SYS/MB/SP is not
displayed either.
6720583 When the role is changed to Administrator/Operator
using "Active directory" on the ILOM Web interface,
the Role field is still blank.
102 SPARC Enterprise T5140 and T5240 Servers Product Notes • November 2012
done
Workaround
Note - Fixed in System Firmware 7.2.2.e or later.
When the Solaris OS time lagged, restore it according
to the following steps.
1. Shut down the system.
# shutdown -y -i0 -g0
2. Start the system in the single user mode.
{0} ok boot -s
3. Set the system time.
# date setting time
4. Reboot the system.
# shutdown -y -i6 -g0
Note - Fixed in System Firmware 7.2.2.e or later.
After the ILOM reset or the power cord removal and
insertion, when you power on the server, check the
OpenBoot PROM environmental variable. Especially, in
case the OpenBoot PROM environmental variable
use-nvramrc? has been set to true, it is necessary
in advance of starting the Solaris OS to see the ok
prompt and check that use-nvramrc? has been set to
true and then execute the boot command.
Confirmation example:
{0} ok printenv use-nvramrc?
use-nvramrc? = true
{0} ok
Note - Fixed in System Firmware 7.2.2.e or later.
None.
Note - Fixed in System Firmware 7.2.2.e or later.
Use the "set /SP/services/snmp engineid=
(value)" command from the CLI to set engineid.
Note - Fixed in System Firmware 7.2.2.e or later.
Use the show /SYS/MB/SP command.
Note - Fixed in System Firmware 7.2.2.e or later.
Log in to ILOM and verify the defaultrole setting
in /SP/clients/activedirectory.