Fujitsu SPARC Enterprise T5140 Product Notes page 53

Firmware and General Software Issues (Continued)
TABLE 3-4
CR ID Description
n/a In the environment where the Cisco Catalyst switch
series manufactured by Cisco Systems are connected
with the ILOM network management port (NET-
MGT), when you execute the switching restart or the
enable/disable operation of the network port, the
Cisco Catalyst switch and the ILOM network port
LEDs may not turn on, and the network linkup fails.
Due to this, access to ILOM using protocols such as
SSH (Secure Shell) fails.
The prtdiag Command Doesn't Show the Correct
Memory Configuration in the Output, in the
Configuration with Different Memory Capacities (CR
6842745)
The prtdiag command doesn't show the correct memory configuration in the output, in the
following memory configuration:
CMP0/Branch0
CMP1/Branch0
It shows the memory size (48928 Megabytes) correctly.
Output example:
# prtdiag -v
System Configuration:
Memory size: 48928 Megabytes
:
:
======================= Physical Memory Configuration ========================
Segment Table:
--------------------------------------------------------------
Base Segment
1.55V 2GB DIMMx4
/Branch1 1.55V 2GB DIMMx4
1.55V 4GB DIMMx4
/Branch1 1.55V 4GB DIMMx4
Sun Microsystems
Interleave
Workaround
Use the Cisco IOS software 12.2(53)SG / 12.2(46)SE
version or later.
In case that the 12.2(53)SG / 12.2(46)SE version or
later cannot be applied, you can install other
hub/switch between the Cisco Catalyst switch and the
ALOM/ILOM network management port to avoid
this event.
It is already confirmed that this event can be avoided
using the switching hub manufactured by Fujitsu.
Perform the ILOM reset operation.
sun4v SPARC Enterprise T5240
Bank Contains
Chapter 3 Known Issues 43