Fujitsu SPARC Enterprise T5140 Product Notes page 51

Firmware and General Software Issues (Continued)
TABLE 3-4
CR ID Description
6591634 During OpenBoot PROM at the system start, when
you execute a forced dump order from ILOM, a
FATAL error message appears in the console log and
the following boot order fails.
Event example:
{0} ok
FATAL: /virtual-devices@100/console@1:
Last Trap: Non-Resumable Error
:
:
{0} ok boot
FATAL: system is not bootable, boot
command is disabled
n/a In an environment where the keyboard has been
connected to the USB port of the server, when you
restarted Solaris OS, OpenBoot PROM may output
the "Failed to set idle" message to the
console log.
Event example:
# /usr/sbin/shutdown -i6 -y -g0
:
Resetting...
Failed to set idle
SPARC Enterprise T5120, Keyboard Present
Copyright (c) 1998, 2011, Oracle and/or
its affiliates. All rights reserved.
<--
Workaround
To recover this event, power off and then power on
the system.
When OpenBoot PROM became no response, execute
a break order, not a forced dump order, from ILOM.
If not recovered by the break order, power off and
then power on the system.
None.
Due to the OpenBoot PROM issue, there is a problem
in the data reference after the idle setting to the USB
keyboard has been completed. Therefore, this has no
impact on the server and the connected USB
keyboard. The output message can be safely ignored.
Chapter 3 Known Issues 41