Removing And Installing The Top Cover - AMT Datasouth AMTACCEL-5350 User Manual

User's Guide

Removing and Installing the Top Cover

Figure 5-1. Removing the Top Cover
WINDOW
SUPPORT
TAB
Figure 5-2. Aligning the Platen Window
and Top Cover
5-2 Cleaning and Maintenance
Maintenance and troubleshooting proce-
dures require you to remove the top cover
CLIPS
to access internal printer components.
To remove the top cover, simply lift up the
front edge, as shown in figure 5-1.
To re-install the top cover, perform the
following procedure:
1. Position the platen window between
2. Press down on the top cover until the
3. Lower the top cover back into place.
CLIP
MOUNTING
TABS
the back edge of the top cover and the
window support tabs, as shown in
figure 5-2.
clips snap onto the mounting tabs.