AMT Datasouth AMTACCEL-5350 User Manual page 183

Function
Ignore .................................
Continue printing? ............
Bell ......................................
Backspace ..........................
Horizontal tab ....................
Line feed .............................
Vertical tab ........................
Form feed ...........................
Carriage return ................
Enable characters with .....
codes outside normal range
Table D-2. AMT and Diablo 630 Control Codes
ASCII Hexadecimal
NUL 00
ETX 03
BEL 07
BS 08
HT 09
LF 0A
VT 0B
FF 0C
CR 0D
SO 0E
Decimal
0 The printer ignores this code unless it is used within an
escape sequence.
3 With the ETX / ACK serial handshake in use, this code
causes the printer to return an ACK control code when it
can receive more data. When ETX/ACK is not in use, the
code prints the assigned character.
7 This code sounds the audible alarm for a brief period.
8 This code moves the current print position one character
space to the left. If the current print position is the left-
most, the printer ignores this code.
9 This code moves the current print position right to the next
horizontal tab stop on the current line. If no tab stop is set
to the right of the current print position, the audible alarm
sounds and the printer ingnores this code. If the factory
defaults are in effect, tab stops are set every eight print
positions across the page.
10 This code advances the paper one line space. If the current
line position is the last printable line on the page, the printer
performs a form feed instead of a line feed.
11 This code advances the paper to the next vertical tab stop.
If no vertical tab stop is set below the current line posi-
tion, the audible alarm sounds and the printer ignores
this code.
12 This code performs one of the following actions:
If a single sheet is loaded, the printer ejects the sheet.
If pin-feed paper is loaded, the printer advances the
paper to the next top-of-form or top margin if one is set.
If an automatic sheetfeeder is installed, the printer loads
a new sheet from the active bin. The sheet feeds to the
top-of-form or top margin if one is set.
13 This code moves the current print position to the left mar-
gin. If automatic line feeding is active, the printer performs
a line feed in addition to the carriage return.
14 This code causes one of the following actions:
If an ECS font is not active, this code permits the print-
ing of characters with codes below 20 hex. After re-
ceiving an SO code, the printer does not perform the
usual control functions of subsequent control codes it
receives, but instead prints the assigned characters. An
ESC SI sequence ends this function.
User's Guide
Description
Code Sets D-5