AMT Datasouth AMTACCEL-5350 User Manual page 135

Table 6-1. Troubleshooting Guide––continued
Symptom
Characters overlap each other or
there are wide gaps between them.
Double-high text overlaps text
on the next line.
Double-wide characters overlap.
Foreign symbols replace some of
the standard ASCII characters.
Vertical line drawing and compo-
nent characters do not align.
Printing only occurs from left to
right, not in both directions.
Some of the IBM graphics char-
acters do not print or print as
italic characters.
Printing is not in color.
Printing continues to physical
bottom edge of page on cut sheets,
intead of using LENG setting.
Printer not leaving blank lines (los-
ing line feed) at top of cut sheets.
Probable Cause/Corrective Action
CELL setting on Setup menu
is incorrect; check setting.
Leave a blank line after every
double-high line of text.
Leave a blank space after every
double-wide character.
LANG setting on Setup menu
is incorrect; check setting.
DIRCTN setting on Setup menu
is bi-directional; change setting
to uni-directional.
DIRCTN setting on Setup menu
is uni-directional; change setting
to bi-directional.
SETS setting on Setup menu
is incorrect; check setting.
Color ribbon cartridge is not
installed.
PGE END setting on Setup
menu is off; change setting
to on.
PGE END setting on Setup
menu is off; change setting
to on.
Solving Problems 6-19
User's Guide