AMT Datasouth AMTACCEL-5350 User Manual page 193

Table D-3. AMT and Diablo 630 Escape Sequences––continued
Function
Bold / shadow printing
Start bold ........................
Start shadow ...................
End bold / shadow ..........
Auto underscoring
Start ................................
End .................................
End word processing .........
modes
Slant printing (italics) .......
Start 10-degree slant ......
Start 20-degree slant ......
Start 30-degree slant ......
End .................................
Super / subscripting ..........
Start subscripting ............
Start superscripting .........
End .................................
ASCII Hexadecimal
Text Functions––continued
ESC O 1B 4F
ESC W 1B 57
ESC & 1B 26
ESC E 1B 45
ESC R 1B 52
ESC X 1B 58
ESC @ S n 1B 40 53 n
ESC @ S 1 1B 40 53 31
ESC @ S 2 1B 40 53 32
ESC @ S 3 1B 40 53 33
ESC @ S 0 1B 40 53 30
ESC @ V n 1B 40 56 n
ESC @ V 1 1B 40 56 31
ESC @ V 2 1B 40 56 32
ESC @ V 0 1B 40 56 30
Decimal
These sequences start and end bold or shadow printing
27 79 at the current print position. For bold and shadow printing,
27 87 the printer makes a second printing pass over the line. For
27 38 bold, the printer prints each character twice at the charac-
ter's normal print position. For shadow, the printer prints
each character twice––once at the character's normal print
position, and once 1/120-inch to the right of this position.
The printer ends bold or shadow printing when it receives a
carriage return, End Bold/Shadow Printing sequence, or
End Word Processing Modes sequence.
These sequences start and end underscored printing at the
27 69 current print position. During underscored printing, the
27 82 printer remembers the current print position as the start
location. When printing reaches the end location, the
printer underscores the area between the start location and
the end location. The end location is the print position
when the printer receives an End Auto Underscore or End
Word Processing Modes sequence, a carriage return, or any
paper movement code or sequence. If the end location is
before the start location on the line, no underscoring occurs.
27 88 This sequence ends the program mode, bold printing,
shadow printing, and automatic underscoring . The
sequence also cancels the automatic center mode.
27 64 83 n This sequence starts and ends slant printing, wherein char-
27 64 83 49 acters slant forward to simulate italics. The degree of slant
27 64 83 50 can be 10, 20 or 30 degrees.
27 64 83 51
27 64 83 48 Note: You can turn slant printing on and off as many times
as you like on a line, but you can use only one slant setting.
If you attempt to use more than one slant setting on a single
line, only the last slant setting is used. For example, if you
select 10-degree slant for one word and 20-degree slant for
the next word on the same line, both words will print at 20-
degree slant.
27 64 86 n This sequence starts and ends automatic superscripting and
27 64 86 49 subscripting of characters. Both superscript and subscript
27 64 86 50 characters are half the normal height. Superscript char-
27 64 86 48 acters print above the normal print line; subscript charac-
ters print below the normal print line.
User's Guide
Description
Code Sets D-15