Top Of Form Adjustment - AMT Datasouth Documax 5380 User Manual

Top of form adjustment

The top of form setting determines the margin between the top of paper and
the first printed line (the top margin). The top of the first printed line is the
zero position. Advancing the paper is a positive value, reversing the paper is
a negative value.
When the menu setup mode has specified the left black mark or right black
mark, this is defined as the distance from the black mark to the left or right
edge of paper.
TOF ADJUSTMENT ~
1.
Install paper correctly, press LOAD/EJECT key to feed paper to printing
position. In the ONLINE mode, press the LOAD/EJECT key and LF/FF
key for about 3 seconds at the same time, ONLINE LED and COPY LED
blinks alternately which denotes the printer has entered the adjustment
mode.
2.
Press the LOAD/EJECT key to increase the top of form by 1/60 inch.
You can increase the margin to a maximum of +60 increments (+60/60
inch) from the factory setting. Press the LF/FF key to decrease the top of
form by 1/60 inch. You can decrease the margin to a minimum value of 0
(-19/60 inch) from the default setting.
3.
Press the ONLINE key to exit and save your new setting. The COPY
LED and ONLINE LED blink simultaneously twice with two beeps, and
then the ONLINE LED will stay on.
BLACK MARK ADJUSTMENT ~
1.
Install paper correctly, press LOAD/EJECT key to feed paper to printing
position. In the ONLINE mode, press the LOAD/EJECT key and LF/FF
key for about 3 seconds at the same time, ONLINE LED and COPY LED
blinks alternately which denotes the printer has entered adjustment
mode.
2.
Press the LOAD/EJECT key to adjust the sensor position 1/20 inch. You
can increase the margin to a maximum of +80 increments (+80/20 inch)
from the factory setting, or the LF/FF key to decrease the margin to a
minimum of 0 (0/20 inch) from the default setting.
3.
Press the ONLINE key after adjusting, the COPY LED and ONLINE
LED blink simultaneously twice with two beeps, the new setting will be
saved, then press the ONLINE key again to exit the adjustment mode
entirely.
- 18 -