AMT Datasouth AMTACCEL-5350 User Manual page 203

Table D-5. Epson and IBM Control Codes––continued
Function
Start double-wide print- ...
ing for one line
Start condensed printing ...
Enable printing/X-ON .......
End condensed printing ....
Disable printing/X-OFF ....
End double-wide print- .....
ing on current line
Cancel .................................
Escape ................................
Space ..................................
Delete ..................................
ASCII Hexadecimal
SO 0E or 8E
SI 0F or 8F
DC1 11 or 91
DC2 12 or 92
DC3 13 or 93
DC4 14 or 94
CAN 18 or 98
ESC 1B or 9B
SP 20
DEL 7F or FF
Decimal
14 or 142 This code starts double-wide printing on the current line
and doubles the character spacing to accommodate the
wider characters. A DC4 code or any control code or
escape sequence that causes paper movement ends
double-wide printing and resumes normal character
spacing. The Start/End Double-Wide Printing
sequence also ends double-wide printing.
15 or 143 This code starts condensed printing, wherein character
spacing and character cell size are 17.1 characters per
inch. A DC2 code ends condensed printing.
17 or 145 This code enables printing. If printing is already enabled,
the printer ignores this code. Also, when the X-ON/
X-OFF serial handshake is in use, the printer returns this
code during power-up, reset, and after returning a DC3
(X-OFF) code when it can receive more data.
18 or 146 This code ends condensed printing and sets character
spacing and character cell size to 10 characters per inch.
19 or 147 This code disables printing until the printer receives a DC1
code or the operator presses the Ready button on the
control panel. While printing is disabled, the PAUSE
message appears on the control panel. Also, when the
X-ON/X-OFF serial handshake is in use, the printer
returns this code when it is unable to receive more data.
20 or 148 This code ends double-wide printing started with an SO
code and resumes normal character spacing. This code
does not end double-wide printing started with escape
sequences.
24 or 152 This code cancels the printing of all text on the current
line, but does not affect the control codes.
27 or 155 This code begins an escape sequence.
32 This code moves the current print position one character
space to the right.
127 or 255 When this code follows a character code, the printer
ignores the character code; otherwise, the printer ignores
the delete code.
User's Guide
Description
Code Sets D-25