AMT Datasouth AMTACCEL-5350 User Manual page 134

User's Guide
6-18 Solving Problems
Table 6-1. Troubleshooting Guide––continued
Symptom
Printer leaves blank line after
every print line.
Carriage does not return to left
margin before printing next line.
Printer only prints hexadecimal
numbers.
Printing does not start at far left
print position.
Printer prints on pin-feed paper
perforations.
Printer does not justify or center
text with the corresponding mode
turned on.
Printing starts too far down the
page.
Last line(s) on page print on top
of next page.
Probable Cause/Corrective Action
AUTO LF mode on Setup
menu is on; turn off mode.
LPI setting on Setup menu is
incorrect; check setting.
AUTO CR mode on Setup
menu is off; turn on mode.
HEX MODE on Setup menu
is on; turn off mode.
LFT MAR setting on Setup
menu is incorrect; check setting.
Top-of-form is set incorrectly.
Advance paper until first print
line is under guide lines on
print-line indicator and press
Set top of form button.
LENG setting on Setup menu
is incorrect for paper you are
using; check setting.
AUTO FF mode on Setup menu
is off; turn mode on.
RGT MAR setting on Setup
menu is incorrect; check setting.
TOP MAR setting on Setup
menu is incorrect; check setting.
LENG setting on Setup menu
is incorrect; check setting.