Replacing Seat Positioning Strap; Wheelchairs With Trro Option - Invacare Pronto M71 Owner's Operator And Maintenance Manual

SECTION 14—SEAT

Replacing Seat Positioning Strap

Wheelchairs with TRRO Option

To replace the seat positioning strap, refer to Wheelchair-Anchored Belts on page 107.
Wheelchairs without TRRO Option
ALWAYS wear your seat positioning strap.
The seat positioning strap is a positioning belt only. It is not designed for use as a
safety device withstanding high stress loads such as auto or aircraft safety belts. If
signs of wear appear, belt must be replaced immediately.
NOTE: For this procedure, refer to FIGURE 14.4.
NOTE: This procedure is for ASBA seats only.
1. Remove the two mounting screws, quick release pin tabs, spacers, and locknuts that
secure the seat pan and seat positioning straps to the seat frame.
2. Remove the two halves of the seat positioning strap from the rear seat frame.
3. Reposition the two new seat positioning strap halves to the seat frame.
4. Reinstall the two mounting screws, and locknuts that secure the seat positioning
straps to the seat frame and torque to 75 inch-pounds.
Mounting
Seat Frame
Mounting Screw
Quick-Release
Pin Tab
® ™
Pronto M71 with SureStep
WARNING
Holes
Locknuts
Washers
FIGURE 14.4 Replacing Seat Positioning Strap
™
Seat Frame
Mounting Screw
58
Quick-Release Pin Tab
Seat Positioning Strap
Halves
Part No 1141449