SECTION 15—FOOTBOARD ASSEMBLY
Mounting Hole
Quick Release
Pin
Detent Balls
FIGURE 15.1 Removing/Installing the Footboard Assembly
Adjusting the Footboard Assembly
Angle Adjustment
NOTE: For this procedure, refer to FIGURE 15.2.
1. Loosen the jam nut and set screw
located underneath on the rear of the
footplate.
2. Adjust the mounting screw IN or OUT
to obtain the desired footboard
assembly angle.
3. Thread the jam nut and washer inward
until it is flush with the footboard
bracket.
4. Securely tighten the jam nut and
washer to secure the mounting screw in
place.
®
™
Pronto
M71
with SureStep
Battery Frame
Footboard
Assembly
™
68
Bottom View
Quick Release
Pin
Detent Balls
Outer Edge of
Tube
Set Screw and Jam Nut
Footboard Assembly
FIGURE 15.2 Angle Adjustment
Part No 1141449