Adjustable Seat Back Angle Models (Asba) - Invacare Pronto M71 Owner's Operator And Maintenance Manual

SECTION 19—ELECTRONICS
Armrest
Plate
Locknuts
NOTE: MK5 SPJ Joystick shown. All other joysticks are adjusted the same way.
FIGURE 19.1 Repositioning Joystick - Van Seat Models

Adjustable Seat Back Angle Models (ASBA)

NOTE: For this procedure, refer to FIGURE 19.2.
1. Turn the lever on the adjustment lock to release the adjustment lock from joystick
mounting tube.
2. Remove the joystick from the wheelchair.
3. Remove the three hex screws that secure joystick mounting bracket, the threaded hole
half clamp and the opened hole half clamp to the arm tube.
4. Reposition the threaded hole half clamp and opened hole half clamp on the opposite
arm tube. Make sure threaded hole half clamp is on the inside of arm tube.
5. While holding the two half clamps, install the front hex screw into the two half clamps.
Securely tighten.
6. Line up mounting holes of the joystick mounting bracket with the mounting holes in
the two half clamps.
7. Secure the joystick mounting bracket to the two half clamps with the remaining two
hex screws.
8. Slide tube through the bracket to the desired position.
9. Slide adjustment lock over end of tube and secure adjustment lock to tube by turning
lever on adjustment lock.
NOTE: If adjustment lock does not fit over tube, rotate 180°.
® ™
Pronto M71 with SureStep
Mounting Hex Mounting
Bracket Screws
Adjustment
Lock Lever
Bushings
™
Joystick
Joystick
Mounting
Tube
94
Part No 1141449