Removing/Installing The Center Mount Footrest; Removing; Installing - Invacare Pronto M71 Owner's Operator And Maintenance Manual

SECTION 16—FRONT RIGGINGS
Seat
Frame
STANDARD POSITION
18-inch Wide 20-inch Wide
Holes 2 and 3 Holes 4 and 5
FIGURE 16.6 Adjusting/Replacing Telescoping Front Rigging Supports

Removing/Installing the Center Mount Footrest

NOTE: For this procedure, refer to FIGURE 16.7.

Removing

1. Remove the rigging pivot pin that secures the footrest to the mounting bracket of the
seat frame.
2. Hold the footrest with one hand and
engage the release lever with the other
while simultaneously pulling the
center mount footrest out of the
mounting bracket of the seat frame.

Installing

1. Engage the release lever with one hand,
hold the center mount footrest with the
other, and insert the center mount
footrest into the mounting bracket of
the seat frame.
2. Reinstall the rigging pivot pin to secure
the center mount footrest to the
mounting bracket of the seat frame.
® ™
Pronto M71 with SureStep
Inner Mounting Holes
Seat
Frame
1-INCH OUT
18-inch Wide
Holes 3 and 4
™ 74
Not Used
Spacer
Locknuts
8
7
6
Mounting
Not Used
Holes
2-INCHES OUT
20-inch Wide 18-inch Wide
Holes 5 and 6 Holes 4 and 5
Mounting
Bracket
of Seat
Frame
Center
Mount
Release
Footrest
FIGURE 16.7 Removing/Installing the
Center Mount Footrest
Mounting Bolts
Telescoping
Front Rigging
Support
5
4
3
2
Hinge Pins
20-inch Wide
Holes 6 and 7
Seat Frame
Lever
Rigging Pivot Pin
Part No 1141449