Emergency Stop/Reset Switch - Invacare Pronto M71 Owner's Operator And Maintenance Manual

The Information Center can display:
ITEM
Speedometer
Trip Odometer
Odometer
Trip Amp-Hour meter
Battery Volts
Battery Current
Load Test Results
If a fault is detected, the cause of the fault will be scrolled across the second line of the
display.
DRIVE I
E
FIGURE 12.7 MPJ Joystick Switches and Indicators - LCD Display

Emergency Stop/Reset Switch

The emergency stop/reset switch is used to stop the wheelchair and to select the operating
mode for the wheelchair. The switch input is located on the control module next to the
joystick input. An emergency stop/reset switch is needed whenever any of the following
operating modes are programmed:
• Environmental Controls (E.C.U.) - including recliner controls
• 3 Speed Mode in Momentary
• Latched Modes
• Pneumatic Control
• Stand-by Mode
• RIM Control
• Remote Drive Selection Mode
• Information Center Display Selection (does not require Reset activation at power up)
If any of the above modes are selected, the control will require activation of the switch
immediately after the power switch is turned on in order to enter the drive mode. The
second line of the LCD will display - PRESS RESET.
Part No 1141449
Current Wheelchair Speed - MPH/KMH
Distance traveled since the wheelchair was last powered ON
Total Distance Traveled (Factory Default) - MI/KM
Battery Capacity consumed since the wheelchair was last powered ON -
AH
Current Battery Voltage - VOLT
Battery current being used - AMP
Current battery condition based on a load test - BATT
MI
F 0000
47
SECTION 12—WHEELCHAIR OPERATION
DESCRIPTION
Pronto
® ™ ™
M71 with SureStep