Depth Adjustment - Invacare Pronto M71 Owner's Operator And Maintenance Manual

Depth Adjustment

NOTE: For this procedure, refer to FIGURE 15.3.
1. Remove the quick release pin that secures the footboard assembly to the wheelchair
frame.
Make sure the detent balls of the quick release pin are fully released and protruding
past the outer edge of the tube before operating the wheelchair. Otherwise, injury
and/or damage may result.
Keep detent balls clean.
2. Adjust footboard to one of three mounting positions.
3. Install the quick release pin. Make sure the detent balls are fully released and
protruding past the outer edge of the tube.
Mounting Hole
Quick Release
Pin
Part No 1141449
WARNING
Battery Frame
Three Depth
Adjustment Holes
Footboard
Assembly
FIGURE 15.3 Depth Adjustment
69
SECTION 15—FOOTBOARD ASSEMBLY
Bottom view
Quick Release
Pin
Outer Edge of
Tube
Pronto
Detent Balls
® ™ ™
M71 with SureStep