Section 19-Electronics; Repositioning Joystick; Van Seat Models - Invacare Pronto M71 Owner's Operator And Maintenance Manual

SECTION 19—ELECTRONICS
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that ON/OFF
switch on the joystick is in the OFF position.

Repositioning Joystick

Van Seat Models

NOTE: For this procedure, refer to FIGURE 19.1.
NOTE: Take note of position and orientation of mounting hardware for reinstalling the joystick
assembly.
1. Turn the adjustment lock lever to release the joystick mounting tube from the
mounting bracket.
2. Remove the joystick from the wheelchair.
3. Remove the three hex mounting screws, bushings and locknuts that secure the
mounting bracket to the three mounting holes on the armrest plate.
NOTE: The mounting bracket is mounted to the inside of the armrest plate.
4. Reposition the mounting bracket on the opposite armrest plate.
5. Using the three hex mounting screws, bushings and locknuts secure the mounting
bracket to the three mounting holes of the armrest plate.
6. If necessary, perform the following to reposition the adjustment lock:
A. Slide the adjustment lock from the mounting bracket.
B. Rotate adjustment lock 180° and slide adjustment lock over the opposite end of the
mounting bracket.
7. Slide joystick mounting tube through the mounting bracket to the desired position
and secure adjustment lock to tube by turning lever on adjustment lock.
Part No 1141449
WARNING
93
SECTION 19—ELECTRONICS
® ™
Pronto M71 with SureStep
™