Installing/Removing Flip Back Armrests; Installing; Removing - Invacare Pronto M71 Owner's Operator And Maintenance Manual

SECTION 13—ARMS

Installing/Removing Flip Back Armrests

Make sure the flip back armrest release and height adjustment levers are in the
locked position before using the wheelchair.
NOTE: For this procedure, refer to FIGURE 13.3.
NOTE: Flip back armrest release lever must be in unlocked position when placing armrest into the
arm sockets.

Installing

1. Slide the flip back armrest into the arm sockets on the wheelchair frame.
2. Install the quick release pin through the rear arm socket and flip back armrest.
3. Lock flip back armrest by pressing flip back armrest release lever into the Locked
(Vertical) position.
4. Lift Up on flip back armrest to make sure the armrest is locked in place.
5. Repeat STEPS 1-4 for opposite flip back armrest.

Removing

1. Unlock flip back armrest by pulling flip back armrest release lever into the Unlocked
(Horizontal) position.
2. Remove the quick release pin that secures the flip back armrest to the wheelchair
frame.
3. Pull Up on the flip back armrest and remove the armrest from the arm sockets.
4. Repeat STEPS 1-3 for the opposite flip back armrest, if necessary.
Flip Back Armrest
Rear Arm Socket
Quick Release Pin
Front Arm Socket
FIGURE 13.3 Installing/Removing Flip Back Armrests
® ™
Pronto M71 with SureStep
WARNING
™ 54
Locked
(Vertical)
Flip Back Armrest
Release Lever
Unlocked
(Horizontal)
Seat Frame
Part No 1141449