SECTION 14—SEAT
Removing/Installing the Seat Assembly
NOTE: For this procedure, refer to FIGURE 14.5.
NOTE: This procedure is for wheelchairs WITHOUT the Formula PTO Plus seating system
installed ONLY. For wheelchairs with the Formula PTO Plus seating system, refer to Tilting the
Seat Assembly on page 60.
Removing
1. Disconnect the joystick cable at rear of seat. Refer to Disconnecting/Connecting the
Joystick on page 95.
2. Push down on the latch bar underneath front of seat.
3. Rotate seat assembly backward.
4. Slide the seat assembly forward to disengage seat from pivot brackets located in the rear.
Installing
1. Position the seat in the rear pivot brackets as shown in FIGURE 14.5.
2. Rotate seat assembly forward.
3. When seat is lowered, engage seat brackets into seat clevis pins.
WARNING
When reinstalling the seat verify that the seat brackets are engaged with the seat
clevis pins by pulling up on the latch bar.
4. Pull up on latch bar to verify that brackets are engaged with seat clevis pins.
Rear Pivot
Brackets
Seat Clevis
Pins
Latch Bar is located
under the front of the
seat
FIGURE 14.5 Removing/Installing the Seat Assembly
59
®
™
™
Part No 1141449
Pronto
M71
with SureStep