Required Items - Cisco UCS C210 Installation And Service Manual

Upgrading a Server Earlier Than Release 1.2(2) For Cisco UCS Manager 1.4 or
2.0(1) Integration
This section describes the process for upgrading a server that was shipped prior to the 1.2(2) release so
that it can be integrated with UCS Manager 1.4(1x) or 2.0(1x).
The server must be a Generation M2 (or later) server.
Note
Release 1.3(x) does not support UCS integration. Do not upgrade your server later than 1.2(2xx) if you
Note
want to use the server in UCSM mode with UCS Manager 1.4 or 2.0(1).
See the following URLs for additional information about the equipment in this configuration.
•
•

Required Items

The hardware configuration described in this procedure provides redundant network fabrics and paths
for both management traffic and data traffic. The following items are required to create this
configuration.
•
•
Note
Note
•
•
•
•
Cisco UCS C210 Server Installation and Service Guide
D-14
For information about the Cisco UCS 6100 Series or 6200 Series fabric interconnects (FIs) in the
configuration, see the documentation at the following links:
Cisco UCS 6100 Series Fabric Interconnect documentation
–
Cisco UCS 6200 Series Fabric Interconnect documentation
–
For information about the Cisco Nexus 2248 fabric extenders (FEXes) in the configuration, see the
documentation at the following link: 
Cisco Nexus 2000 Series Fabric Extender documentation
A Cisco UCS system running Cisco UCS Manager software release 1.4(1x) or 2.0(1x).
A Cisco UCS C-Series M2 server with a Cisco 10-Gb adapter card installed.
This server CIMC and BIOS firmware must be at version 1.2.(1a) or later before you can use the
Cisco Host Upgrade Utility as described in this upgrade procedure.
If you install a Cisco UCS P81E Virtual Interface Card (N2XX-ACPCI01), see
Considerations for the Cisco UCS P81E Virtual Interface Card (N2XX-ACPCI01), page
To use this card for UCS integration, the minimum card-firmware level is 1.4(1i).
A physical VGA monitor and a USB keyboard. You can use a KVM dongle on the front-panel KVM
connector or connect directly to the server ports.
The Cisco UCS C-Series 1.2(2xx) standalone software release container for your server. The
software release is distributed on Cisco.com as an ISO file that contains the Host Upgrade Utility
and required firmware.
(Optional for local upgrades) A writable DVD with at least 23 MB of space.
Two Cisco UCS 6100 Series or 6200 Series FIs.
Appendix
Special
3-35.
OL-20887-02