Cisco UCS C210 Installation And Service Manual page 70

Install a PCIe riser card assembly:
Step 2
Replace any PCIe card in the new riser card assembly.
a.
b. Set the assembly in place, aligning the riser cards with the PCIe slots on the motherboard.
c. Press down evenly on both ends of the assembly to fully engage the riser cards with the PCIe slots
on the motherboard.
Note
Replace the screw that secures the assembly to the chassis.
d.
Replace the top cover.
e.
Replace the server in the rack, replace power cords and any other cables, and then power on the
f.
server by pressing the Power button.
Figure 3-17
1 Riser card assembly (top view)
Cisco UCS C210 Server Installation and Service Guide
3-32
Older servers have a screw that secures the PCIe riser to the rear of the chassis, but newer servers
do not have this screw. If your server has the screw, continue with the next step to replace it. If
your server does not have this screw, skip to Step
Removing and Replacing a PCIe Riser Card Assembly
1
1
e.
2
2 Riser card
Chapter
OL-20887-02