Cisco UCS C210 Installation And Service Manual page 105

Appendix
Step 6 Use the supplied KVM cable to connect a keyboard and VGA monitor to the console connector on the
front panel (see
Note Alternatively, you can use the VGA and USB ports on the rear panel. However, you cannot use the front
panel VGA and the rear panel VGA at the same time. If you are connected to one VGA connector and
you then connect a video device to the other connector, the first VGA connector is disabled.
Reboot the server.
Step 7
To view and configure settings for the server from within the Cisco UCS Manager software, see the
Step 8
information instructions in the
Figure D-2
2
1 Cisco UCS 6100 Series or 6200 Series FI
(Fabric A)
2 GLC-T transceiver in FEX port
(Fabric A)
Cisco Nexus 2232 FEX 
3
(Fabric A)
4 Cisco UCS 6100 Series or 6200 Series FI
(Fabric B)
5 GLC-T transceiver in FEX port
(Fabric B)
The paths shown in blue carry management traffic. The paths shown in gold carry data traffic. The paths
Note
shown in green carry both data and management traffic.
OL-20887-02
Figure 1-1).
Cisco UCS Manager Configuration Guide, Release 2.0
Cabling Configuration for Cisco UCS Manager 2.0(2xx) Integration
1
Fabric A
10Gb
3
7
4
5 6
10Gb
1Gb
8
Cisco Nexus 2232 FEX 
6
(Fabric B)
7 Cisco UCS C210 M2 server
8 1-Gb Ethernet LOM ports Eth1 and Eth2
9 10-Gb adapter card in PCIe slot 1
Cisco UCS C210 Server Installation and Service Guide
or later.
Fabric B
10Gb
9
D-5