Cisco UCS C210 Installation And Service Manual page 76

Press down evenly on both ends of the assembly to fully engage the riser cards with the PCIe slots
f.
on the motherboard.
g. Replace the screw that secures the assembly to the chassis.
Replace the top cover.
h.
Replace the server in the rack, replace power cords and any other cables, and then power on the
i.
server by pressing the Power button.
Step 3 Restore the RAID configuration on your drives to the new mass storage controller.
See Restoring RAID Configuration After Replacing a RAID Controller, page
Figure 3-21
1
Riser card assembly removed from chassis
3 PCIe card
5 Securing screw (attaches to assembly)
Cisco UCS C210 Server Installation and Service Guide
3-38
Removing and Replacing a PCIe Card
1
4
2
3
C-6.
5
2
Riser card
4 PCIe card rear plate
Chapter
OL-20887-02