Cisco UCS C210 Installation And Service Manual page 86

Supported Power Cords and Plugs
Each power supply has a separate power cord. Standard power cords or jumper power cords are available
for connection to a power distribution unit that has IEC 60320 C19 outlet receptacles. The jumper power
cords, for use in racks, are available as an optional alternative to the standard power cords. For more
information, contact Cisco technical support.
The standard power cords have an IEC C19 connector on the end that plugs into the Power Distribution
Unit (PDU), which is located in the bottom slot at the rear of the chassis. The optional jumper power
cords have an IEC C19 connector on the end that plugs into the chassis' PDU and an IEC C20 connector
on the end that plugs into an IEC C19 outlet receptacle.
Only the approved power cords or jumper power cords provided with the server are supported.
Note
Table B-1
Table B-1
Description
SFS-250V-10A-AR
Power Cord, 250 VAC 10 A IRAM 2073 Plug 
Argentina
CAB-9K10A-AU
250 VAC 10 A 3112 Plug, 
Australia
SFS-250V-10A-CN
Power Cord, 250 VAC 10 A GB 2009 Plug
China
CAB-9K10A-EU
Power Cord, 250 VAC 10 A M 2511 Plug
Europe
SFS-250V-10A-ID
Power Cord, 250 VAC 16A EL-208 Plug
South Africa, United Arab Emirates, India
SFS-250V-10A-IS
Power Cord, 250 VAC 10 A SI32 Plug 
Israel
CAB-9K10A-IT
Power Cord, 250 VAC 10 A CEI 23-16 Plug 
Italy
CAB-9K10A-SW
Power Cord, 250 VAC 10 A MP232 Plug 
Switzerland
Cisco UCS C210 Server Installation and Service Guide
B-2
lists the power cords for the server power supplies
Supported Power Cords for the Server
Length
Feet Meters
8.2 2.5
8.2 2.5
8.2 2.5
8.2 2.5
8.2 2.5
8.2 2.5
8.2 2.5
8.2 2.5
Appendix
Power Cord Reference
Illustration
Figure B-2
Figure B-3
Figure B-4
Figure B-5
Figure B-6
Figure B-7
Figure B-8
Figure B-9
OL-20887-02