Cisco UCS C210 Installation And Service Manual page 53

Chapter
To replace or install a hot-pluggable hard drive or SSD, follow these steps:
Remove the drive that you are replacing or remove a blank panel from an empty bay (see
Step 1
Press the release button to expose the ejector lever.
a.
b. Pull the ejector lever toward you, and then pull the drive sled from the drive bay.
c. If you are replacing an existing drive, remove the drive from the sled by removing the four screws
from the sides of the sled.
Step 2 Install a new drive:
a. Place the drive in the sled with the connectors facing the rear.
b. Install the four securing screws on the sides of the sled.
With the ejector lever still open, push the sled into the drive bay until you feel the drive stop against
c.
the backplane.
d. Press the ejector lever flat until the lock clicks into place.
Figure 3-6
HDD_07
HDD_12
Figure 3-7
1 Release button
3 Securing screws (four on sides of sled)
OL-20887-02
Drive Numbering and Physical Orientation, Facing Server Front
HDD_08
HDD_13
Removing and Replacing Hard Drives and SSDs
3
3
HDD_01 HDD_02
HDD_04 HDD_05
HDD_09 HDD_10
HDD_14 HDD_15
1
2
3
3
2 Ejector lever
Cisco UCS C210 Server Installation and Service Guide
Figure 3-7):
HDD_03
HDD_06
HDD_11
HDD_16
3-15