Chapter 2
Installing WLSE 1130-19 Hardware
Precautions for Products with Modems, Telecommunications, or
Local Area Network Options
Tools and Equipment Required for Installation
Installing WLSE 1130-19 Hardware
78-16778-01
Observe the following guidelines when working with options:
Do not connect or use a modem or telephone during a lighting storm. There
•
may be a risk of electrical shock from lightning.
Never connect or use a modem or telephone in a wet environment.
•
Do not plug a modem or telephone cable into the Ethernet connector.
•
•
Disconnect the modem cable before opening a product enclosure, touching or
installing internal components, or touching an uninsulate4d modem cable or
jack.
Do not use a telephone line to report a gas leak while you are in the vicinity
•
of the leak.
You need the following tools and equipment to install the WLSE:
Number 2 Phillips screwdriver
•
Tape measure and level
•
•
Antistatic mat or antistatic foam
ESD grounding strap
•
This section provides instructions for installing the WLSE in a rack. The rack
must be properly secured to the floor, ceiling, or upper wall, and where applicable,
to adjacent racks. The rack should be secured using floor and wall fasteners and
bracing specified by industry standards.
This section contains the following topics:
Installation Quick Reference, page 2-12
•
Installing the WLSE 1130-19 in a Rack, page 2-12
•
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
Installing WLSE 1130-19 Hardware
2-11