Enabling The Mezzanine Card Raid Controller In The Bios; Raid Controller Cabling - Cisco UCS C210 Installation And Service Manual

Appendix

Enabling the Mezzanine Card RAID Controller in the BIOS

When using the supported mezzanine-style RAID controller cards, you must enable the ICH10R
controller in Enhanced mode.
Make sure that a RAID cable is attached between the mezzanine card and the disk backplane.
Step 1
Boot the server and press F2 when prompted to enter the BIOS Setup utility.
Step 2
Select the Advanced tab, then Mass Storage Controllers Configuration.
Step 3
Step 4 Set Onboard SATA Controller to Enabled.
Step 5 Set SATA Mode to Enhanced.
Step 6 Press F10 to save your changes and exit the utility.
To set up a RAID configuration when using the mezzanine card, boot the server and press Ctrl-C when
Step 7
prompted to start the WebBIOS utility.

RAID Controller Cabling

The RAID controller connectors in this server are shown in
recommended cable routing path from the backplane to the possible controller locations.
Figure C-1
1 Extender or expander backplane
2 Integrated RAID connector on
motherboard
OL-20887-02
RAID Controller Connectors
1
2
Figure
3
3 Mezzanine card connector
4 LSI MegaRAID PCIe card connectors
Cisco UCS C210 Server Installation and Service Guide
C-1. The blue line indicates the
4
C-3