Required Items - Cisco UCS C210 Installation And Service Manual
Generations m1 and m2
Hide thumbs
Also See for UCS C210:
- Installation and service manual (114 pages) ,
- Configuration manual (88 pages) ,
- Setup (10 pages)
Table of Contents
Advertisement
Appendix
Figure D-1
For more information on FEX discovery policies and port-channel allocation, see the
Manager Configuration Guide, Release 2.0 or later.
Required Items
The hardware configuration described in this procedure provides redundant network fabrics and paths
for both management and data traffic. The following items are required to create this configuration.
•
•
Note
•
Note
•
Note
•
•
•
OL-20887-02
Six Sets of Ports in the Fabric Interconnect (Including Expansion Module)
1
3
5
7
9
11
13
15
2
4
6
8
10
12
14
16
1
2
A Cisco UCS system running Cisco UCS Manager software release 2.0(2xx) or later.
A Cisco UCS C210 M2 server at CIMC release 1.4(3c) or later, with a 10-Gb adapter card installed.
If you install a Cisco UCS P81E Virtual Interface Card (N2XX-ACPCI01), see
Considerations for the Cisco UCS P81E Virtual Interface Card (N2XX-ACPCI01), page
To use this card for integration with Cisco UCS Manager 2.0(2xx) and later, the minimum
card-firmware level is 2.0(2g).
Two Cisco UCS 6100 Series or 6200 Series FIs.
The switch ports that carry server traffic must be enabled as server ports.
Two Cisco Nexus 2232 FEXes.
You must plug a power cord into each of the two power supplies in each FEX. If a power supply
is not connected to power, you might see "Major" faults reported during power-on self test
(POST). For example,
connecting the missing power cord to the FEX power supply.
Two RJ-45 Ethernet cables.
Six 10-Gb SFP cables.
Two 1000BASE-T SFP transceivers (GLC-T)
17
19
21
23
25
27
29
31
18
20
22
24
26
28
30
32
3
4
Power supply 1 in fex 6 power: error
Cisco UCS C210 Server Installation and Service Guide
1
3
5
7
9
11
13
15
2
4
6
8
10
12
14
16
5
6
Cisco UCS
Special
. You can clear these errors by
3-35.
D-3
Advertisement
Table of Contents
