Connecting The Camera(S) To The Htrd400 Recorder; Camera Aiming And Focusing; Aiming The Camera - Honeywell HTRD400 Reference Manual

Installation

Connecting the Camera(s) to the HTRD400 Recorder

Camera Aiming and Focusing

Aiming the Camera

Rev 1.02
The HTRD400 Recorder has four RJ45 connectors for connecting up to four HTCD50 Digital
Cameras.
Connect the CAT5 straight data/power cable connector from each camera into a CAMERA
ONLY port on the rear panel of the HTRD400 Recorder (see
which CAMERA ONLY port you choose as the unit powers them all at the same time.
After the HTCD Digital Camera base is mounted, use the Toolbox application on a PC or
laptop connected to the HTRD400 Recorder to:
• Configure the connected camera
• Fine tune FOV adjustments
• Position, aim, and focus the camera
• Set the image quality and resolution
• Confirm the video coverage
Note This section explains how to position, aim, and focus an HTCD Digital
Camera. To set image quality, resolution, and frames per second see
Configuring the
1. On a connected PC or laptop, start the Toolbox application.
2. Add and configure the camera (see
3. On the camera, loosen the pan thumbnut and tilt screws (x2) to adjust the camera to
the desired view.
HTCD50 camera: See
HTCD52 camera: See
Confirm the desired field of view and image quality on the Camera Edit screen (see
Configuring the Camera(s), page 50).
Camera(s), page 50.
Configuring the
Figure 2-11.
Figure 2-12.
22
Figure 2-9). It does not matter
Camera(s), page 50).
Document 900.0328
05/05