Table of Contents
Advertisement
Getting Started
Connecting a PTZ Camera
Attaching the Four-Wire PTZ Adapter
________________________________________________________________________________________________________
18
Setting up a PTZ camera is simple. The DVR comes preassembled with an internal
PTZ adapter. Honeywell recommends using CAT 5 cable which typically can be run at
lengths up to 1500 feet.
Signal Line (-)
1.
Locate the PTZ adapter cable (included in the Fusion accessory box).
Connect the wires of the PTZ adapter to the PTZ camera. The red wire should
2.
connect to the RX+ on the camera and the brown wire should connect to the RX-.
Note
The PTZ adapter has four wires but only two are necessary for this
application; the yellow and orange wires are not used currently.
3.
Connect the other end of the adapter to the DVR as shown.
4.
Assign the PTZ camera an ID number that coincides with the number assigned to
it by the DVR in the PTZ Setup Interface.
Example If the camera is plugged into input 5 set the PTZ unit to ID number 5.
Signal Line (+)
PTZ Adapter
Document 900.0803 Rev 7
02/29
Advertisement
Table of Contents
