Table of Contents
Advertisement
Solutions
If this happens ...
Lost video
Lost audio
HTRD400 Recorder does not
"wake up".
HTRD400 Recorder does not
enter Record mode.
Poor quality images
Uneven audio or playback rate
Player does not display GPS data.
Player displays GPS Data Not
Connected....
Rev 1.02
Try this ...
Check:
•
Cable connections, including sensor and RJ45 connector
•
Power to the camera
•
Camera settings
Check:
•
That audio is enabled (see
•
The audio (microphone) connection from the camera (see
Camera(s), page 16).
Check:
•
Configuration settings (see
page 47)
•
Fault LED
•
Temperature LED
Test the triggers.
Check the configuration settings (see
page
46
or
Configuring or Modifying Trigger
Test the triggers.
•
Refocus or adjust the aim on the camera.
•
Change the compression from Extended to Good, Good to Better, or
Better to Best.
See
Configuring the
Camera(s), page 50.
Ensure that your PC meets the minimum system requirements (see
System
Requirements, page 28).
Confirm that the Record GPS data when a rule is active field is checked on
the GPS Summary window (see
Confirm that the Status box on the GPS Summary window shows "Detected"
(see
Configuring
GPS, page 55).
If it does not, check that the GPS module is correctly installed. Refer to the
HTGPS Module Installation Application Note
136
Figure 5-9
on
page
51).
Configuring or Modifying Trigger
Configuring Recorder Global
Inputs, page 47).
Configuring
GPS, page 55).
for installation information.
Installing the
Inputs,
Settings,
PC
Document 900.0328
05/05
Advertisement
Table of Contents
